17
Marchesan Implementos e Máquinas Agrícolas “TATU” S.A.
Adjustments and operations
Fertilizer distribution
Procedure for sprockets changing
The fertilizer distribution is done through the steel auger and the different dosage
rates of fertilizer, by changing the sprocket of drive shaft {C} (14,18,22,26,30,34 and 38
teeth) and driven shaft {D} (14,18,22,26,30,34 and 38 teeth).
RECÂMBIO DE ENGRENAGENS
SPROCKET COMBINATIONS
CAMBIO DE ENGRANAJES
ADUBO
FERTILIZER
ABONO
EIXO MOVIDO
DRIVEN SHAFT
EJE MOVIDO
EIXO MOTOR
DRIVE SHAFT
EJE MOTOR
D
C
• Move the lever (A) to alleviate the chain tighter and lock with the locker pin in the
hole.
• Displace Manually the sprockets combination cone on the axle and align the choosing
sprocket with the chain.
• Loosen the lever for liberating the lock pin.
• The bolts (B) on the sprockets combination
cone of “TRA”, are calibrated in the factory,
allowing the sprockets change without use of any tool.
• In case of any sliding motion on cone shaft, just loose the
counter nut and made only once turn around the bolt, and
re-lock.
• In order to avoid damage to the spring and shafts, never
apply excessive torque when tightening the bolts and
nuts.
IMPORTANT
NOTES
B
A
Look in the following pages the different quantities of fertilizer,
according with the sprockets combination.
The fertilizer distribution table of this manual, should be used just like a reference to
start the planter calibration. Factors as slippage index of the planter carrying wheels
(skidding), work speed more than the recommended (5 km/Hour), tires inflation less
than recommended and field conditions, can introduce values a bit different from
those indicated in the tables. Therefore, it is always indispensable make the practical
distribution tests as indicated in page 19 of this manual.
Содержание Cassava Planter
Страница 1: ......
