WIL-19230-E-01
Wilden
®
4
The following outlined Precautions are for the
Wilden SafeGuard equipment only. For specific
Precautions on your pump, please refer to your
pump model manual.
WARNING:
Always wear safety glasses when
operating a pump to avoid eye injury. If diaphragm
rupture occurs, material being pumped maybe forced
out of the air exhaust.
CAUTION:
Before attempting any maintenance or repair,
disconnect the compressed air line to the pump and allow all
air pressure to bleed from the pump. Disconnect all intake,
discharge, and air lines. Drain the pump by turning it upside
down and allowing any fluid to flow into a suitable container.
Be aware of any hazardous effects of contact with your
process fluid.
WARNING:
For more details on Cautions and Warnings
for the pump that the SafeGuard system is to be installed,
or is installed on, please see the associated pump model
manual. All pump manuals are available on
www.wildenpump.com Download Library.
CAUTION:
When removing the end cap using compressed
air, the air valve end cap may come out with considerable
force. Hand protection such as padded glove or rag should
be used to capture the end cap.
CAUTION:
The SafeGuard Gateway Node must be
mounted within 150 feet of the installed SafeGuard Edge
Devices to ensure proper operation. Impediments between
the pump, Edge Device and Gateway Node can cause this
range to vary. The SafeGuard Gateway Node can handle up
to 10 SafeGuard Edge Devices.
WARNING:
Changes or modifications which are not expressly
approved by Wilden could void the authority to operate the
equipment.
NOTE:
SafeGuard complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions: (1) this device
may not cause harmful interference and (2) this device must
accept any interference received, including interference that may
cause undesired operation.
NOTE:
The SafeGuard Gateway Node contains licensee-
exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licensee-
exempt RSS(s). Operation is subject to the following two
conditions: (1) this device may not cause interference and (2)
this device must accept any interference, including that may
cause undesired operation of the device.
NOTE:
SafeGuard has been evaluated for RF Exposure
per RSS-102 and is in compliance with the limits specified
by Health Canada Safety Code 6. The system must be
installed at a minimum separation distance from the
antenna to a general bystander of 8 inches (20 cm) to
maintain compliance with the General Population limits.
NOTE:
SafeGuard is not an ATEX Certified product and
using the equipment on an ATEX compliant pump, voids
the ATEX Certification.
PRECAUTIONS – READ FIRST!
Section 1
Содержание Wilden SafeGuard
Страница 15: ...WIL 19230 E 01 Wilden Notes ...
