PSC PowerWedge 10, Руководство пользователя

Страница: 31 / 116

Programming the PowerWedge 10
User’s Guide
26
4. The PowerWedge 10 that you want to program is called the “slave.”
Set the On/Off/Program switch on the slave to the
OFF
position.
5. Connect the free end of the cloning cable to
INPUT
1 on the slave.
6. Set the On/Off/Program switch on the slave to the
PRGM
position.
The parameter settings from the master PowerWedge 10 will imme-
diately be copied into the slave. The slave will indicate successful
programming by beeping three times and repeatedly flashing its
green LED twice.
7. Turn the slave off and disconnect the cable from it.
8. Repeat steps 4 through 7 to make additional clones.
General Programming Parameters
Table 1 describes some of the general parameters for programming the
PowerWedge 10. Page references indicate where to find bar codes for set-
ting the parameters. For descriptions of serial parameters, see page 28. For
information about magnetic stripe programming parameters, see page 33.
For a complete list of parameters and defaults, see
Programming Options on
page 34
.
Table 1. General Programming Parameters
I.D.
#
PARAMETER DESCRIPTION
05 Code 39 full ASCII
(page 52)
Supports the Code 39 extended ASCII character set (see
Full Keyboard Support on page 81
). For example, a character
string encoded in Code 39 as +A is transmitted as a
lowercase a . This allows every key of the keyboard to be
encoded in a Code 39 bar code.
25 Codabar wide
intercharacter gaps
(page 63)
Allows reading of Codabar bar codes printed with large
gaps between characters.
33,
36
UPC conversion
(page 69)
Converts UPC-A bar codes to EAN-13 (I.D. #33), and
converts UPC-E bar codes to UPC-A (I.D. #36).