PSC LazerData 12000 Series, Руководство по установке

Страница: 25 / 58

LazerData
®
12000 Scanner Installation Manual
2.8 - Installation
2.6.2 Wiring the JBOX
To electrically wire the JBOX–
1) Open the junction box by unscrewing the four cover screws.
2) Pass all system cables through the compression connectors in the JBOX
housing.
3) Connect the power and input/output signals:
•
Prepare the individual wires of the system cables by stripping the insulation
back approximately 11 mm (0.43 inch).
•
Using a screwdriver or other tool, push down on the orange lever directly
above the clamp (see Figure 2.8).
•
Insert the wire into the clamp and release the lever. The wire will now be
held in the spring clamp.
Figure 2.8 - System cable connections to the junction box
The wiring used can be solid or stranded but must meet the following
specifications.
Positions 1-4: 24 - 16 AWG 0.2 - 1.5 mm²
Positions 5-39: 26 - 20 AWG 0.14 - 0.5 mm²
The JBOX pinouts are indicated in the following table.