PS Audio® Inc. 800PSAUDIO 4865 Sterling Drive Boulder, Colorado 80301
11
11
Operating Manual
Note: It is not necessary to enable Wifi or connect the Ethernet for normal playback operation
of the PST.
The network connection should be to an internet-connected router or through a wireless
Ethernet bridge connected to a router. The PST’s Internet connection via the network cable will
be automatic through any DHCP-enabled network. Most Internet setups in the home or office
are DHCP-enabled and connection should take place within a very short period of time.
You can look on the front panel display for verification of connection. When you are connected
to the internet and the PST is powered up Ethernet icon will be displayed on the icon bar at the
top of the screen. If the network is not connected, no icon will appear in the icon bar.
The PST can also receive factory firmware updates via its network connection, should they
become available. In addition, the PST has a built-in Wi-Fi antenna, which can be used to
receive factory supplied network firmware updates.
Powering the PST
Once all the digital audio and network connections are made, use a high quality AC cable to
connect the PST to an AC wall outlet or AC outlet of a power conditioner. The supplied AC
power cord will work but upgrading to a high-end power cord, as well as the use of a PS Audio
Power Plant AC Regenerator if possible, will offer sonic benefits.
PS Audio produces an entire line of high-quality power cables that are generally accepted
as being some of the best in the industry. Whatever you choose, make sure it honors the
music.
Turn the AC power switch on the rear of the PST to the ON position. The power switch is
located above the AC inlet as you face the rear panel.
