Installation and Operating Instructions
AV-3000 and AV-5000 Power Centers
4826 Sterling Drive, Boulder CO 80301
15-052-21-1 Rev B
PH: 720.406.8946 [email protected] www.psaudio.com
©2009 PS Audio International Inc. All rights reserved.
NOTE –
Devices with large inrush currents, such as amplifiers, should only be placed on the parallel
filtering outlets. Although other outlets will power such devices, large inrush currents may damage the
relays which control the on and off settings of the outlet.
Connect Phone
To protect any device which connects to the telephone line connect the telephone cable from the wall
outlet to the “TELEPHONE IN” jack on the PS AV Power Center. Then connect the telephone cable to the
“TELEPHONE OUT” jack on the PS AV Power Center and to the device.
Connect Satellite / Cable / Antenna
To protect satellite, cable, and/or antenna devices connect the coaxial cable from the wall to the coaxial
“IN” jack on the PS AV Power Center. Then connect the coaxial cable to the vertically grouped “OUT” jack
on the PS AV Power Center and to the device.
Connect to the Network
To protect any device which connects to the internet, connect the Ethernet cable from the wall outlet to
the “DATA IN” jack on the PS AV Power Center. Then connect the Ethernet cable to the “DATA OUT”
jack on the PS AV Power Center and to the device.
To enable web based control connect an Ethernet cable from a live connection to the “ETHERNET” jack
on the PS AV Power Center.
2.4
Self Test and Power Up
When the PS AV Power Center is plugged into the wall or when it recovers from a power failure it will run
a short self test. During the self test the device will illuminate the display window and display model and
firmware information
Upon completion of the self test the PS AV Power Center may be turned on by pressing the PS Audio
blue logo button in the center of the front panel.
2.5
IP Status
Once connected to the internet the PS AV Power Center’s proprietary internet connection service will
auto detect and configure the required settings. An IP status indicator light is provided on the front panel
to indicate the status as follows:
R
R
e
e
d
d
– PS AV Power Center is not connected to the local network. Check to make sure the
Ethernet cable is connected and an active network connection.
B
B
l
l
u
u
e
e
(
(
A
A
V
V
-
-
5
5
0
0
0
0
0
0
)
)
o
o
r
r
G
G
r
r
e
e
e
e
n
n
(
(
A
A
V
V
-
-
3
3
0
0
0
0
0
0
)
)
– The Power Center is connected to the local network
and the Web. Configuration and control can now be performed through internal website.
By default the PS AV Power Center is setup to rely on a DHCP enabled router or switch. If you are unable
or do not wish to enable DHCP on the router or switch please refer to section titled
2.6.2 Internal Website
Configuration
to configure the PS AV Power Center as a static device within the local network.
