7
Attaching cross member arms to wall bracket
Determine which set of holes to attach the cross member arms to (PRx
Performance recommends Set #2)
1. Use Set #1 if you do not have, or do not intend to get, the PRx Wall-Mounted Folding Bench.
This allows the uprights to be nearly flush to the wall when folded in
2. Use Set #2 if you currently, or may in the future, own a PRx Wall-Mounted Folding Bench.
This set provides an additional 6” of space from the wall to accommodate the Folding Bench
and other small items to be stored between the rack and wall when the rack is folded in
Attaching cross members
1. Place the Cross Member (5) into the C Bracket (3) section
of the wall bracket aligning the second hole of the Cross
Member and Hole Y of the C Bracket
* Note: The upright will be in the unfolded position
2. Using one 5/8” x 6” Bolt (10), two 5/8” Washers (13) and
one 5/8” Nylock Nut (11), hand tighten. Then place a
Hitch Pin (12) into Hole W (and the first hole of the Cross
Member) to lock the Cross Member into place
3. Continue this on the remaining three
4. Once all cross members are attached to the wall brackets
and locked into place, fully tighten the 5/8” x 6” Bolt (10)
and 5/8” Nylock Nut (11) into place. Be sure not to over
tighten
* Note: When tightening these bolts the C Bracket (3)
should not bend
Set #1
Set #2
Z
Y
X
W
Z
Y
X
W
Set #1
Set #2
13
11
10
12
3
5
