Lower cross-
member height
Holes up from
bottom of upright
7.5”
9.5” **
11.5” **
13.5” **
15.5” **
17.5” **
2 & 5
3 & 6
4 & 7
5 & 8
6 & 9
7 & 10
Lower Cross Member Recommendations
Upper cross-
member height
Holes down from
top of upright
Pull-up bar
height options
67.5” 69.5” 71.5” 73.5” 75.5” 77.5”
10 & 13
9 & 12
8 & 11
7 & 10
6 & 9
5 & 8
72.5” - 88” 74.5” - 88” 76.5” - 88” 78.5” - 88” 80.5” - 88” 82.5” - 88”
Upper Cross Member Recommendations
Attach cross members to uprights
1. Attach cross members to the lower and upper part of the upright
according to primary athlete’s height. It is recommended to attach
the lower Cross Member (5) below the athlete’s knees, and the
upper cross member slightly above eye level. Refer to chart for
approximate heights according to hole placement on the upright
* Note: Bottom of uprights have hard rubber foot plugs
2. Using two 5/8” x 4.5” Bolts (9), four 5/8” Washers (13) and two
5/8” Nylock Nuts (11), hand tighten the bolts in the designated
holes to attach the cross members to the upright. Continue
securing the remaining three cross members to both uprights
3. Approximate measurements for cross-member placement:
Cross members can be adjusted in 2” increments up or down
in order to better fit the designated space. Be sure the cross
members have a minimum spacing of 50” between the upper and
lower cross members to provide proper support. The following
recommendations are approximate and should be treated as
such with the cross-member heights referring to the approximate
center of each of the cross members
** If you currently own or plan to own a PRx Wall-Mounted Folding Bench, avoid using any measurements between 9.25”
and 19.25” for the lower cross member as it will interfere with mounting the Folding Bench. For more information about the
Folding Bench see page 9
1
13
9
11
5
