3. Preparing the Case
The case is made up of six printed parts, some of them being optional:
a. The Base Box
b. The Anchor Shim
c. The PSU Clip
d. The Reset Switch Block
e. The Pi Bezel
f. The Lid
4. Fitting The Anchor Shim
The case has a separate anchor shim. This allows custom conduits to be installed.
If no custom conduit is used, then the shim can be used.
Simply plug the shim in from the rear – it will be a friction fit, and permanently
locked in place when the Pi case is bolted to the frame.
- 6 -
c
b
e
d
a
f
