8
Before installing this product, turn pump off
(Diagram 1) CSS 10 Mounting Instructions
·
Mount CSS10 in vertical position to a flat surface above the return line to you pool
·
Position Salt Generator Cell in Mounting bracket attached to bottom of Control Box,
with wire connector leads at bottom
·
Position loose mounting bracket over top of Salt Generator Cell and fasten to surface with screws
(Diagram 2) ByPass Installation Instructions
·
Drill 2 holes (use 7/8” hole saw drill bit ) in return line
a. One 7/8” hole between pump and filter
b. One 7/8” hole after filter and heater ( must be last installation going back to pool)
c. This needs to be at lowest point of pressure so water can return to main pipe)
(Diagram 3) Assemble the Saddle Clamp
(Diagram 4)
·
Attach Saddle Clamp over hole after pump
·
Insert injector into top of Saddle Clamp, (small ports pointing away
from hole) push injector through Saddle Clamp into hole in return line
·
Measure and cut ¾” hose to fit distance between injector and bottom of salt cell
(View B)
·
Place two metal clamps on ¾” hose
·
Attach one end of ¾” hose to top of injector, tighten with metal clamp
·
Attach other end of ¾” hose to bottom of salt cell, tighten with metal clamp
Flow
7/8 inch Hole Saw
7/8 Inch hole
1 1/2 ” Install only
Spacer for 1 1/2 ” assembly
Salt Generator Cell
CSS 10 Power Box
C
SS
Complete Sanitation System
™
Automated System Control
O
ZONE
S
ALT/
C
HLORINATOR
S
YSTEM
C
SS
Complete Sanitation System
™
Automated System Control
OZONE SALT/CHLORINATOR SYSTEM
Diagram 1
Diagram 2
Diagram 3
Diagram 4
