
n
2
Vin
Setup and Operations Manual © 2008
13
Check the Bottom Nuts on the Bottle Heads as described above. They must be firmly
hand tight. Insert the Bottle Head into the neck of an opened bottle. You can do this in
the cabinet or with the bottle standing on the drip tray by simply pulling the Head to the
bottle. Insert the Wine Tube into the bottle seating the head fully. Tighten the
Compression Wheel until it is difficult to slide the Bottle Head up and down in the bottle
neck. Do not over tighten. (If looking from the top, the wheel tightens by turning in a
clockwise direction.)
When the bottle is properly connected, you should just be able to lift it by the bottle
head without loosening or pulling it out.
Turn the Bottle Head gas valve on by moving it UP.
When this is done with all five bottles, you are n2Vin!
BEST PRACTICES
Your n2Vin creates in all practical terms an anaerobic environment within the bottle. It is,
therefore, best for you to leave an empty bottle sealed in place (with the gas valve,
now, OFF) than to remove the Bottle Head and allow the Wine Tube to be exposed to
the environment for any length of time.
If a bottle is empty, leave it connected or
replace it immediately!
As one bottle empties, it is best to change to a fresh bottle as quickly as possible.
Please
open the next bottle before removing the empty.