n
2
Vin
Setup and Operations Manual © 2008
11
The n2 is now ready to load as is discussed below, but it needs to be cleaned with the
provided B-Bright cleaner, a safe, specialized formulation. So loading, for the moment, is
going to require a couple empty wine bottles. It is also a dress rehearsal for loading and
dispensing wines.
An initial cleaning should be done at this time.
Please refer to Appendix
Three covering cleaning procedures.
ELECTRICAL AND CONTROL
Because the Gas and Electrical systems are entirely separate, wine can be preserved
and dispensed as can all cleaning functions be performed without an electrical
connection. However without an electrical connection, there is no refrigeration and no
lighting. If the n2Vin is to be used in a climate-controlled cellar, it is possible to set
temperature high to avoid compressor operation (and the heat output from it), while still
providing power for the internal lighting. Contact ProWine or your dealer for special
conditions such as this, as there are several modifications you can easily make to suit
special circumstances.
Be sure your model is in the appropriate voltage for your location. Plug the IEC
(computer) end into the back inlet of the n2Vin and the other end into a wall outlet.
You will see three bars in the temperature display.
Push the leftmost button
(Main Switch) holding it in until you hear a small chirp.
Main Switch | Temp & Settings
Temperature Display | Compressor |Light | Manual Defrost
The system will be ON. The display will show (generally) room temperature.
To protect the compressor against liquid lockup, a compressor delay of 2 minutes is
programmed into the control. In two minutes the compressor will start.
To set Temperature or see the current temperature setting, press the SET button once and
let go.
The target temperature setting will show - flashing.
