Provision DVR-906M, Системное руководство

Страница: 34 / 73

PRO-VISION
®
Video Systems
32 provisionusa.com
Digital HD Exterior Camera Installation
The Waterproof Night Vision Camera (Kit P/N: DVR-816, Camera
P/N: PC-1816) is designed to mount on the rear of a vehicle and
capture the area directly behind the vehicle. This camera has a
horizontal coverage of a ~120° that provides a clear image of objects
while covering a wide area. This camera is often used in applications
where capture capturing a clear and detailed view both day and night
is important. The camera has built in high intensity night vision and a
light sensor to automatically enable the night vision when necessary.
With its waterproof IP-67 housing, this camera can be mounted to the
exterior of the vehicle and handle all weather conditions.
Mounting Location:
This camera is often used on the rear of the bus to provide video capture backup
incidents and traffic behind the bus. The camera can only be mounted to a
horizontal surface, it can be mounted above, below, or directly to the mounting
surface and can adjust up to 180°. The camera mounting screw holes are slotted
to allow the camera to be aimed left or right after mounting.
Installation:
17. Gently spread the two sides of the bracket apart and
slide the camera in place with the pivot pins on each side
of the bracket aligned to the center hole on each side of
the camera as show in the image to the right.
18. Locate the desired mounting location of the camera. It is
recommended to power on the DVR unit and temporarily
connect the camera to it and observe that the view in the
desired mounting location is satisfactory before
proceeding to the next step.
19. When the desired mounting location is found, mark or measure
the two (2) mounting screw hole locations in the bracket
(Shown in
ORANGE at right). If necessary, remove the camera
from the bracket.
20. If the cable will be routed through the vehicle body, typically it
is routed through a 5/8” holed drilled directly in the center of the
vehicle body behind the bracket (Shown in
RED color above).
Mark and drill this hole if needed. Remove any burrs from the hole
to prevent damage to the cable.
21. Install the camera bracket to the marked locations from step 3
(Shown in ORANGE above). Ensure the bracket is oriented for
properly aim as shown in the image at right, if needed flip the
bracket 180°.
22. Install the camera into the bracket by spreading the bracket apart slightly and aligning the center
holes on each side of the camera with the pivot pins on the bracket.
Pivot Pin
Direction of Camera Aim