Protocol neo-drone AP, Инструкция по эксплуатации

Страница: 17 / 20

Neo-Drone AP
does not
respond
1. Communication between
controller and aircraft was not
synchronized during set up
2. Battery power depleted on
aircraft, controller or both.
1. To synchronize, turn on aircraft,
place it on the ground, and then
turn on the remote.
2. Charge aircraft and/or replace
batteries in controller.
Response to
control inputs
intermittent
or erratic
1. Controller battery power
nearly depleted.
1. Replace batteries in controller.
Neo-Drone AP
will not hover
or strafe
correctly
1. The aircraft was not
on level ground during
synchronization.
2. Trim settings are incorrect.
1. Re-synchronize aircraft
and controller.
2. Reset the trim buttons on the
controller and re-trim flight controls.
*Allow 15 minutes to pass between full flights as this will give the motors a chance
to cool down. Failure to do so could wear out and shorten the life
of the motors.
HOW TO CHANGE THE BLADES
- All drones have two rotors that spin clockwise and two rotors that spin
counter-clockwise.
-
Make sure to place the blades on the correct axis or they will not spin
correctly and the drone will not lift.
- Each blade is marked on its underside with A or B. There may be a number
after the letter but you can ignore the number.
- Make sure to follow the graphic below to see where to place the blades.
FRONT
OF
DRONE
TROUBLESHOOTING
13
POSSIBLE CAUSE SYMPTOM POTENTIAL SOLUTION
MAIN
BLADES A
MAIN
BLADES B
MAIN
BLADES A
MAIN
BLADES B