INSTALLING THE BLADE GUARD
If not already installed, install the included blade guards by sliding and snapping
them in. Make sure the blade guards are secure and snug.
NOTE:
Loose blade guards may interfere
with propeller movement and cause
a crash. If the drone crashes, double
check to make sure the blade guard
is not loose. If it is, re-tighten
before flying.
INSTALLING THE PHONE CLAMP
1. Remove the clip cover from the remote control.
2. Insert the phone clamp into the now empty slot on the remote.
3. Open the clamp to fit the phone.
REMOTE BATTERY, BLADE, BLADE GUARD & PHONE INSTALLATION
1. Install batteries carefully.
2. Do not mix old and new batteries.
3. Do not mix different types of batteries.
Unscrew and remove battery cover from controller. Insert 4 x ‘AA’ batteries
according to indicated polarities. Replace and
screw back in battery cover.
4
INSTALLING THE BLADES (If not pre-installed)
1. Install the blades by sliding them onto the shaft.
2. Push down and twist to the left or right to secure. It may help to hold the
motor with your other hand while twisting.
3. Make sure to follow the correct
position. A blades should go onto
the arms marked A, B blades
should go onto the arms marked B.
*To remove blades, hold onto the
motor to keep it steady. Push down
and twist left or right to remove blade.
