TROUBLESHOOTING
POSSIBLE CAUSE
SYMPTOM
POTENTIAL SOLUTION
Kodiak GPS
does not
respond
1. Communication between
controller and aircraft was not
synchronized during set up
2. Battery power depleted on
aircraft, controller or both.
1. To synchronize, turn on the
remote and then turn on drone.
2. Charge aircraft and/or replace
batteries in controller.
Response to
control inputs
intermittent or
erratic
1. Controller battery power
nearly depleted.
1. Replace batteries in controller.
Kodiak GPS
will not hover
or strafe
correctly
1. The aircraft was not
synchronized properly.
2. Trim settings are incorrect.
1. Re-synchronize aircraft
and controller.
2. Recalibrate the Altitude Sensor.
RE-CALIBRATING THE ALTITUDE SENSOR
If the drone crashes and after re-starting and trimming, it still is unstable, you have
the option to re-calibrate the drone.
1. Turn on the drone and then the remote and sync.
2. Push and hold the both the throttle and direction stick to the lower right
corners for 2-3 seconds.
3. The lights will flash to indicate that the drone has re-calibrated.
LOW BATTERY RETURN
The drone’s lights will start to flash twice every second when the battery is low.
The drone will start to return home.
LOST SIGNAL
When the drone loses its signal for more than 6 seconds, the lights will start to
flash once every second. The drone will start to return home. If the signal is
restored, press Return Home to terminate the return flight.
*Allow 15 minutes to pass between full flights as this will give the motors a chance
to cool down. Failure to do so could wear out and shorten the life of the motors.
13
