· Structural defects,
· Anti-corrosion coating defects
According to the requirements of EN 365 the anchoring point shall be subject to
periodical inspections carried out at least every 12 months. Periodic inspection
shall be carried out by service point authorized by the Manufacturer located at
the following address:
PROTEKT Grzegorz Łaszkiewicz
ul. Starorudzka 9
93-403 Łódź
or person trained in inspections of such equipment.
A trained person is a person who, based on own specialized education and
adequate experience, has sufficient knowledge in installed protective and
rescue equipment, and is familiarized with applicable OHS regulations,
guidelines and generally acknowledged technical rules to such extent that is
able to assess safety of use and correct application of protection devices.
Before each use of the system check whether date of the next inspection is not
expired. Do not use the device after this date. Before each use of the system
visually check the system for its integrity and technical condition and whether
steel cable is tensioned. If any defect or lack of integrity is found, do not use the
point.
If any doubts arise as for the use of the equipment, please contact the
manufacturer and never repair the equipment on your own!
A system which has been used to arrest a fall must be withdrawn from use
immediately!
The system which has been used to arrest a fall may be admitted for use again
after a detailed inspection is carried out by the manufacturer or an authorised
service point.
Pay particular attention to risks affecting the protective equipment operation or
the user's safety, and in particular to kinks and rope movement on sharp edges,
oscillatory falls, electricity, influence of extreme temperatures, equipment
damage, negative influence of environmental factors, chemical substances and
contamination. Do not modify, repair components of the system or replace
them with non-original spare parts.
Manufacturer:
PROTEKT - Starorudzka 9 - 93-403 Lodz - Poland
tel. +4842 6802083 - fax. +4842 6802093 - www.protekt.com.pl
Notified body for
E
U
type examination
according to PPE Regulation 2016/425:
APAVE
SUD
EUROPE
SAS
(no 0082)
–
CS
60193
–
F13322
MARSEILLE
CEDEX
16
- FRANCE
Notified body for control production:
APAVE
SUD
EUROPE
SAS
(no 0082)
–
CS
60193
–
F13322
MARSEILLE
CEDEX
16
- FRANCE
5/5
IDENTITY CARD
SERIAL
/BATCH
NUMBER
It is the responsibility of the user organisation to provide the identity card and to fill in the
details required.
The identity card should be filled in before the first use by a competent
person, responsible inthe user organization for protective equipment.
Any information about
the equipment like periodic inspections, repairs, reasons of equipment's withdra
wal
from use
shall be noted into the identity card by a competent person
in the user organization.
The
identity card should be stor
ed
during a whole period of equipment utilization.
Do not use the
equipment without the identity card.
MODEL AND TYPE OF EQUIPMENT
PERIODIC
INSPECTION
AND REPAIR HISTORY
CARD
REFERENCE
NUMBER
DATE OF
MANUFACURE
DATE OF
FIRST USE
DATE OF PURCHASE
NEXT
INSPECTION
DATE
DATE OF
INSPECTION
REASON FOR
INSPECTION
OR REPAIR
DEFECTS
,
CONDITION
NOTED
REPAIRS CARRIED OUT
NAME AND SIGNATURE
OF COMPETENT
PERSON
USER NAME
