Protege PRT-CTRL, Руководство по установке

Страница: 9 / 36

7 Protégé System Controller Installation Manual
INSTALLATION
Package Contents
When receiving the PRT-CTRL Protégé System Controller you should find the kit contains the
items listed below. The kit type is clearly labelled on the packaging. Please note that if you do
not have the correct contents contact your distributor immediately.
PRT-CTRL-PCB Protégé System Controller PCB Only
Contents: Controller Printed Circuit Board
Plastic Mounting Standoffs
36 1K Ohm Resistors
Red/Black Backup Battery Wires
Location and Mounting
The Protégé System Controller is available as a PCB Only (Printed Circuit Board) or complete
unit supplied with a metal cabinet. It is recommended that the cabinet provided be used
where possible, as this provides the best mounting and installation solution as well as the
required cable entry and termination space.
When installing the Protégé System Controller ensure that there is adequate clearance around
all sides of the enclosure and air flow to the vents of the enclosure are not restricted.
It is recommended to install the Protégé System Controller in a location that will facilitate
easy access for wiring. It is also recommended that the Protégé System Controller is installed
in electrical rooms, communication equipment rooms, closets or in an accessible area of the
ceiling.
1. Insert the plastic stand-offs in to the locations to mount the PCB board.
2. Calculate the location and position of the enclosure and mark the holes for the keyhole
points in the top left and right locations. This will allow you to screw in the screws and
then hang the box on them adjusting the location to suit.
3. Ensure a solid fixing point and screw in the two screws. Before tightening the top
screws insert the tamper bracket in the slot provided on the right side of the
enclosure.
4. Fix the enclosure securely using the remaining mounting holes on the bottom left,
right and centre of the enclosure.
5. If you are extending the System Controller by the addition of a communications
module or memory interface insert the 4 extended nylon standoffs through the rear of
the controller PCB as shown in the interface board manual.
6. Insert the PCB in to the enclosure and mount using the plastic standoffs inserted
during step one.
It is recommended to install the enclosure when the circuit board is NOT installed
on the plastic stand-offs as this will reduce the risk of damage caused by debris
during the installation.
Cabinet Tamper Switch
The enclosure tamper input signals to the monitoring station or remote computer that an
enclosure has been opened. The tamper input switch should be mounted into the steel