Protege PRT-CTRL, Руководство по установке, Страница: 16 / 36

14 Protégé System Controller Installation Manual
Figure 16 - Expansion Connector and Mounting Hole Location
When installing the daughter board ensure that the plastic mounting hardware provided is
correctly inserted from the rear of the system controller PCB. Pay attention to the key location
of the 40 Way Connector.
Figure 17 - Connection and Mounting
Power to the system controller MUST be turned off when connecting any hardware
or system device to the system controller. Failure to do so may damage the system
controller and expansion device.
Ethernet 10/100 Network Interface
The communication between the Protégé SMGT System Management Suite and the Protégé
System Controller uses a 10/100 ethernet network operating the TCP/IP protocol suite. The IP
address of the controller can be configured using the LCD Keypad Terminal. The default IP
address is set to a static IP address of 192.168.1.2 with a subnet mask of 255.255.255.0.
These IP address settings are commonly used for internal networks.
Installing the Protégé System Controller on an active network requires knowledge
of the configuration and structure for the network. Always consult the network or
system administrator and ask them to provide you with a fixed IP address that can
be assigned to the Protégé System Controller.
When installing an ethernet connection the Protégé System controller should be interfaced
using a standard segment (<100M in length) and should be connected to a suitable ethernet
hub or switch.