V4.0_2021-05-26
PROGNOST C Instructions for use
5073-0-0002
PROTEC GmbH & Co. KG, In den Dorfwiesen 14, 71720 Oberstenfeld, Germany
18 von 30
5
Safety and Maintenance
WARNING!
Caution, risk of electric shock!
Turn off the PROGNOST C
before cleaning or disinfecting. This disconnects the
PROGNOST C
from the power source and avoids the risk of electric shock.
5.1
Introduction
In this chapter you will find information about safety and maintenance that are necessary to ensure the
correct and reliable function of the device after installation.
5.2
Reusability
The PROGNOST C can be reused without any special preparation procedures.
However, it must be ensured that the surfaces in contact with patients are disinfected before the X-ray
examination of each patient (see also chapter 4.1).
The PROGNOST C must no longer be used with patients if it shows signs of wear (e.g., metal abrasion,
wear of insulations) or dangerous technical defects (e.g., torn cable, bent parts) or if the resulting image
quality (e.g., artifacts in the image) is insufficient.
In this case, please contact PROTEC service department or a service company authorized by them
immediately.
5.3
Cleaning and Disinfection
NOTE
Caution!
Possible material changes!
WARNING!
Make sure that no liquid enters the interior of the housing during cleaning
and disinfection in order to prevent electrical short circuits and/or corrosion.
5.3.1
Cleaning
The use of corrosive or abrasive cleaning agents as well as solvents is not allowed. These materials can
cause damage to the outer surface of the unit or to the coating of the individual components.
The X-ray mattress is equipped with a Velcro
®
system. To make cleaning easier, the mattress can be
removed to clean the areas underneath and the mattress itself. After cleaning, the X-ray mattress must
be reattached to the X-ray system table. Make sure that it is positioned correctly.
The X-ray mattress can be cleaned moist. Use warm water and a mild cleaning agent. If necessary, wipe
the product with a damp cloth and let it dry thoroughly. Don’t use any abrasive or bleaching agents
and sharp-edged objects for cleaning.
Clean the outer surfaces of the unit and all painted components using a damp towel and a mild – light
alkaline cleaning agent (e.g. RBS* Neutral T). Dry the components off following cleaning.
Chrome components should be cleaned by being wiped down with a dry woolen cloth
5.3.2
Disinfection
Disinfection must be performed in accordance with the applicable legal requirements and guidelines
corresponding to disinfection and explosion protection.
