Prostat PMT-872A, Руководство пользователя

Страница: 8 / 20

8
Rev. A / December 2006
PMT-872A Wrist Strap/Footwear Auditor
3. Slide the wrist strap cuff assembly over your wrist
a. Make sure that the wrist strap is fi rmly ghtened around your wrist
b. Do not a empt to test a wrist strap that hangs loosely from your wrist
c. An improperly worn wrist strap will indicate a FAIL on the PMT-872A
4. Insert the wrist strap grounding cord male banana
plug into the test “Test Input” receptacle located at
the top end of the PMT-872A.
5. Push the “Press to Test” bu on with your index fi nger
a. Press fi rmly, but do not apply excessive pressure
b. You will no ce that the LED’s light up while at-
temp ng to automa cally “range”. With an ac-
ceptable Wrist Strap the LED light sequence will
be:
(1) Ini ally, the HIGH FAIL and LOW BATT. LED’s should light briefl y.
(2) The HIGH FAIL LED goes off , the PASS LED
comes on and the LOW BATT. LED remains
on.
(3) The PASS LED remains on and the LOW
BATT. LED goes off .
(4) An audible “Beep” begins to sound when
the test is completed and the Wrist Strap
is within the acceptable resistance range
while being worn.
6. Once the Green PASS LED is stable and the audible
BEEP begins to sound, the test is completed. It indicates the Wrist Strap is within the accept-
able resistance range and is being properly worn.
If the Green PASS LED does not come on, and either FAIL LED lights, the Wrist Strap is unac-
ceptable or is being worn improperly.
C. Tes ng a Standard, Single Conductor Wrist Strap While
Holding The Cuff
1. Place the PMT-872A toggle switch in the UP , Wrist
Strap posi on.
2. A ach the wrist strap ground cord to the wrist strap
cuff
3. Hold the wrist strap cuff between your thumb and
index fi nger as follows: