Prostat PMT-872A, Руководство пользователя

Страница: 7 / 20

7
Rev. A / December 2006
PMT-872A Wrist Strap/Footwear Auditor
1. Posi on the toggle switch to the UP (Wrist Straps)
posi on and push the “Press to Test” bu on.
a. The HIGH FAIL and LOW BATT. LED’s should come
on briefl y upon release of test bu on.
b. The LOW BATT LED goes off . and the HIGH FAIL
remains on.
2. Posi on the toggle switch to the DOWN (Footwear)
posi on and push the “Press to Test” bu on.
a. The HIGH FAIL and LOW BATT. LED’s should come
on briefl y.
b. The LOW BATT LED goes off and the HIGH FAIL
remains on.
C. Cleaning
1. Wipe the surface of the footplate and the test but-
ton with a so cloth dampened with 70% alcohol and
water solu on. Allow thorough drying.
2. Dust off any lint.
VI. Normal Opera ons
These procedures assume that a fresh ba ery is properly installed and the unit has been func onally
tested for proper opera on. For informa on regarding comprehensive tes ng of the PMT-872A, refer
to Sec on VII “Func onally Tes ng the PMT-872A”, on Page 13.
A. Confi rming Opera on Prior to Use
1. Pre-Test the PMT-872A by pressing the test bu on
a. The RED HIGH FAIL LED and the “Low Ba .” LED will light simultaneously
b. If the ba ery is good, the Low Ba LED will go off a er 1 second
c. The RED HIGH FAIL LED will stay on con nuously
2. You are now ready to perform Wrist Strap or Footwear
tests
B. Tes ng a Standard, Single Conductor Wrist Strap While
Being Worn
1. Place the PMT-872A toggle switch in the UP, Wrist
Strap posi on.
2. A ach the wrist strap ground cord to the wrist strap
cuff