ProStart CT-3400 TW, Руководство по установке

Страница: 8 / 32

P. 8
Installation Guide
CT-3400 TW
up the Ignition and Glow-plug circuits and simply wait for the time-out before
starting:
•
Connecting the Glow-plug input wire of the Remote Car Starter to
Ignition will hold the ignition
ON
for the maximum waiting time (18 sec.,
recommended).
•
Keeping the Glow-plug input wire of the Remote Car Starter
unconnected will hold the ignition
ON
for the minimum waiting time (3
sec., not recommended in very cold environments).
Connect the Glow-plug wire to the Ignition wire only after the Tach
programming has been completed: connecting the Glow-plug wire is one of
the very last steps in the installation process.
2-Pin Harness
Wire Description
2 BLUE / WHITE
This output will provide a 1-sec. negative output (500 mA) when the
UNLOCK
button is pressed a second time on the transmitter (priority door
access) or otherwise when the
LOCK
button is pressed (horn
confirmation).
3
YELLOW
(-) Parking Light
output
500 mA negative Parking Light output
Note: Ensure that the voltage does not vary when the dimmer control
switch is turned up or down. If this is the case, it is not the right wire.
There is a also a positive Parking Light output. Only one of
these two different outputs needs to be connected.
Flashing the Hood Pin
What is Flashing the Hood Pin?
It is a procedure that makes the module enter the programming centre. Once the module is
in the programming centre, the installer has no more than 20 seconds to get into one of the
sub-menus.
Failure to do so will result in the module exiting the programming centre
and the installer will have to flash the hood pin once more.
Remember: You can use the programming
assistance button instead of the hood pin at any
time the hood is up.
The Installer … The Module …
1- Press and hold the hood pin for 4 seconds.
2- Let go of the hood pin.
Parking lights “ON”
3- While the parking lights are “ON”, press down the hood
pin once more.
4- Release the hood pin again —be careful not to over
flash the hood pin as this will bring up the events
playback and will not bring you the programming
centre. “ON” for 20 seconds
5- You now have 20 seconds to select one of the sub-
menus.