CT-3200
Installation Guide
P. 19
30
:
Connects to the vehicle's Trunk release wire.
Comments
: At rest the relay is not active and the vehicle's Trunk release switch is allowed to
operate normally. When the Trunk release button is pressed on the remote control, the
start module's Trunk release output activates the relay. The ground signal is sent from
87 through 30 to the vehicle's Trunk release wire activating the switch and opening the
trunk.
Troubleshooting Poor Transmitting Range
In order to ensure optimal range, the antenna should be installed at least 7.5 cm (3 in.) from
the roof – 2.5 cm (one inch) below the tint strip is generally the best location. Install the
antenna as far as possible from radio antennas, GPS, Onstar or factory compasses.
Many factors may affect the operating range of the transmitter. Some of these are:
•
•
•
•
•
•
•
•
•
•
•
The condition of the battery in the transmitter.
The operating environment (for example: downtown radio-frequency noise,
airports, cellular phone towers…)
Metal: any type of metal will affect operating range. This includes the metal in the
car.
The shape of the vehicle can affect range as well; vans in general have an
especially poor range.
The shape of the roof and A-pillars brings about considerable radio-frequency
deflection (in this case the signal from the remote control). As a result, the
direction in which the vehicle is facing in relation to the remote control can affect
the range. Straight on – standing in front of the vehicle – generally gives you the
greatest range; the second best performance is from the back. Using the remote
control from either side of the vehicle will usually give the lowest range.
The range will be significantly lower in a crowded parking lot than in open space.
Always hold the transmitter high, approximately at shoulder height. Holding the
transmitter against your chin will also increase your range: your head acts as an
antenna.
The operating range will be somewhat lower on vehicles equipped with an
aftermarket or factory alarm.
Windows and windshields tinted with lead or metallic tints will decrease the
operating range.
The antenna cable may have been cut and/or is grounded out on the chassis. Try
using another cable.
The receiver may be faulty. Try replacing it with another.
Trouble shooting Q & A
The following are some common install related issues.
A problem or symptom is given and then possible solutions and/or suggestions as to areas to verify
are enumerated.
1.
I cannot program the remote control.
•
Do the parking lights come on when you open the hood? (Does the hood pin work?)
•
Is the antenna plugged in?
•
Does the light on the remote control turn on when you press the button?
•
Is the Ignition wire connected properly?
•
Are you waiting too long between programming steps?
¾
After flashing the hood pin turn the key to ON, WAIT for 2 seconds.
¾
Turn the key Off, On, Off then keep pressing the
LOCK
button repeatedly until you get
5 light flashes from the module.
