Sequencer
Software
MIDI
Interface
MIDI
Out
Page 5
4. Creating Presets with a Sequencer Software
4. Creating Presets with a Sequencer Software
The presets of the Remote WahWah can be edited using a sequencer software. Of course, a MIDI interface must
be available. MIDI knowledge is required.
The following Control Change commands are used to adjust the parameters
(more on the parameters in
Chapter 5):
CC 07 (0-127) WahWah effect (wah mode), respectively Volume (VCA mode)
CC 89 (0-127) VCA Lowest Value (in VCA mode) *
CC 90 (0-127) WahWah Input Gain
CC 91 (0-127) WahWah Q
CC 92 (0-127) WahWah Coil Rating
CC 93 (0-127) WahWah Frequency
CC 94 (0-127) Contour Boost Frequency
CC 95 (0-127) Output Gain
* In the operation mode WahWah, CC 89 controls the Auto Wah:
Value 0 = Auto Wah disabled
Value 1 = Auto Wah with the sine curve
Value 2 = Auto Wah with the peak curve
CC 72 (off/on) “Do Not Change” VCA Initial Position, disabled / enabled
CC 73 (off/on) “Curve select” A/B
CC 74 (off/on) “Bypass / On”
CC 75 (off/on) “WahWah / VCA” operating mode
CC 76 (off/on) “WahWah” disabled / enabled
CC 77 (off/on) ---
CC 78 (off/on) “Contour Boost” disabled / enabled
CC 79 (off/on) “Auto Enable” disabled / enabled
CC 14 (off/on) Tap (factory default is CC14. However, this value can be modifi ed using the System Manager
software)
NOTE =>
Depending on the active functions, not all the parameters affect the sound.
The following Sysex command has to be sent to save the preset:
F0 00 20 75 00 7F F7
(store to the current preset number)
F0 00 20 75 00 7F XX F7 (store to a specifi c preset number, where XX = preset number)
Basic Settings:
F0 00 20 75 00 70 XX F7 Midi RX Channel (XX = MIDI Channel; 0 = Channel 1, 15 = Channel 16; 16 = Omni)
F0 00 20 75 00 72 XX F7 Auto Disable Time (Time in ms = (20 x XX) + 80 )
F0 00 20 75 00 75 XX F7 Tap CC No (XX = CC No.)
