2
Access
Control
Instruction
Manual
(Note: Use ordinary power wiring need to be in parallel with a diode in both ends of the lock,
Prevent released Back-EMF by electromagnetic to burnout the access control system.)
2 Installation Equipment
2.1 Device Install Step
2.1.1
Recommended installation height is 1.2m from the ground to the camera(Suitable for height of
user: 1.5m-1.8m), kindly adjust by height of user; After the installation height is confirmed, the
installation positioning template is affixed to the installation location, According to the positioning
template identifies drilling and fix it, The red mark is the drilling position (Figure 1);
2.1.2
Find the frame groove position (Figure 2), Gently remove the frame use hand (Figure 3);
2.1.3
That the backing plate bonded to the bottom cover with the device; insert the terminal blocks
into the corresponding interface of the device (Figure 4);
2.1.4
Fit the device to the wall, screw into the wall from the corresponding position (Figure 5);
2.1.5
The frame installed in the corresponding position (Figure 6).
