Access Control Instruction Manual
9
6.4.4 Lock Type Set
There are three types of Lock Type Set: NO, Open, Close; "NO" means not using the door sensor;
"Close" means the door magnetic is close status, If the door is open status, an alarm occurs; "Open"
means the door magnet is open status, If the door is closed more than the set time, an alarm occurs,
the default is NO.
Alarm Delay: After the door is opened or closed, Start detection the setting time of door status.
The maximum can be set 255 seconds, “0” means to turn off the door magnetic delay alarm.
6.4.5 Anti-Pass
Require the verifier to come in from a door and must go out from this door, Records must be strictly
corresponding to have entered and exited, Prevent other people trail in behind you.
针
Mainly use for
two-way verification of the door(Need to verify both in and out), In other words, If you go out without
verification, Then you can no longer enter from this door. Mainly to prevent someone following others
to go out, then secretly sneak into, normally used in banks and other important places.
6.4.6 Turn Off Alarm
After the alarm is triggered, eliminate the wrong operation and stop the alarm by clicking this item.
6.4.7 Tamper Alert
Tamper alert has two statuses: “Yes” and “No”. "Yes" refers to turning on tamper alert function, an
alarm occurs when the device is removed. "No" refers to the closure of tamper alert function, When
the machine is removed, no alarm occurs, Tamper alarm must be set to "Yes" after installation of the
machine, The default is "Yes".
6.4.8 Wiegand Output
Wiegand output includes: user ID and Card number;
6.4.9 Wiegand Format
Wiegand format includes: Wiegand 26, Wiegand 34; "Wiegand 26" refers to Wiegand output signal is
processed, Output in the form of Wiegand 26; "Wiegand 34" refers to Wiegand output signal is
processed, Output in the form of Wiegand 34;
6.4.10 Door Status
Door status refers to set the mark of access records for user, in or out.
7. View Info
Click “View Info” in Settings menu, View info includes: User Log, Reg.Info and Dev.Info.
7.1 User Log
Click “User Log”, Enter the corresponding user ID and press "OK
", Select start and end dates, Time
format: YYYY/MM/DD, Press "OK" to check the user attendance records for the period of time.
