PLX35-NB2
Local Configuration Using the PLX35-NB2 Configuration Webpage
Network Bridge
User Manual
ProSoft Technology, Inc.
Page 16 of 69
2
Use the following table to enter the appropriate parameters:
Parameter
Description
Gateway
Gateway Name
Enter a name for this gateway.
Description
Enter a description to describe the gateway.
For example,
Network Bridge - Bakersfield
.
Address
Enter the street address of the gateway (i.e., where the gateway resides)
Advanced
configuration (link)
This link allows you to provide GPS coordinates of the gateway's location.
Local Area Network
IP
Enter the IP address of the gateway. This is a static IP address. The default
IP address is 192.168.0.250. (The netmask is always 255.255.255.0).
Subnet
Subnet mask of the PLX35-NB2 Ethernet port.
Default Gateway
Default gateway of the PLX35-NB2 Ethernet port.
DHCP Server
Use this parameter to enable or disable DHCP. The default is
Disabled
. If
you want to use a DHCP server to select an IP, select
Enabled
.
Selecting
Enabled
displays a number of additional DHCP-related parameters
DHCP Lease Time
- Allows you to select lease times in hour, minutes, or
seconds. This is the amount of time an IP address remains available on a
particular device before releasing the IP address for use by another device.
DHCP Lease Units
- Allows you to specify Hours and Minutes and works in
conjunction with
DHCP Lease Time
.
DHCP Pool Low
- DHCP uses a pool of assigned addresses that are
available to requests.
DHCP Pool Low
allows you to set the last octet to the
low end number of the pool. (See example below)
DHCP Pool High
- DHCP uses a pool of assigned addresses that are
available for use.
DHCP Pool High
allows you to specify the high-end last
octet of the pool
For example:
This example specifies that the range of addresses that may be used is
between 192.168.72.100 through 192.168.72.249.
NTP
This parameter specifies whether or not the Network Time Protocol
(NTP) is
enabled or disabled. The default is
Enabled
. If
Disabled
, the following two
parameters are not present.
NTP Server 1
Default set to:
0.us.pool.ntp.org
. If you wish to use a different NTP server,
enter it here.
