ProSoft Technology PLX35-NB2, Руководство пользователя

Страница: 11 / 69

PLX35-NB2 Installing the PLX35-NB2
Network Bridge User Manual
ProSoft Technology, Inc. Page 11 of 69
3.1 LED Indicators
The following table describes the diagnostic LEDs on the PLX35-NB2.
LED
State Description
MGMT
Off The module cannot reach the internet and is not managed
by Belden Horizon (default).
Flashing Green The module can reach the internet.
Solid Green The module is managed by a Belden Horizon account.
Solid Red N/A
Flashing Red The module is configured to be managed by Belden
Horizon but cannot reach Belden Horizon.
Alternating Red/Green N/A
VPN
Off Belden Horizon is not enabled (default).
Flashing Green
VPN is possible (normal).
Solid Green A VPN tunnel is established.
Solid Red The module is managed by Belden Horizon and EIP has
disabled VPN tunneling.
Flashing Red VPN connection failed.
Alternating Red/Green
N/A
PWR (Power)
Off Power is not connected to the power terminals or source is
insufficient to properly power the module.
Solid Green Sufficient power is connected to the power terminals.
FLT (Fault)
Off Normal operation
Solid Red A critical error has occurred. Program executable has
failed or has been user-terminated and is no longer
running. Press the
Reset button or cycle power to clear the
error.
CFG
Off Normal operation
Flashing Amber The module has no configuration.
Solid Amber The module is in configuration mode. Either a
configuration error exists, or the configuration file is
currently being downloaded or read. After power-up or
after the
Reset button is pressed, the configuration is read
and the module implements the configuration values and
initializes the hardware.
ERR
Off
Normal operation
Flashing Amber An error condition has been detected and is occurring on
one of the application ports. Check configuration and
troubleshoot for communication errors.
Solid Amber The ERR LED is cleared on receipt of a well-formed
allowed packet. On receipt of data packet containing an
unsupported protocol, the LED is lit. If the LED is solid, a
large number of errors are occurring on one or more ports
(network communication errors).