ILX34-MBS
User Manual
Installing the Adapter
ProSoft Technology, Inc.
Page 8 of 29
2.4
Removing a Mounting Base
In order to remove a mounting base, you must remove any installed module, and
remove the Removable Terminal Block (if wired).
1
Unlatch the RTB handle on the I/O module.
2
Pull on the RTB handle to remove the Removable Terminal Block.
Warning: When you connect or disconnect the Removable Terminal Block (RTB) with the field
side power applied, an electrical arc can occur. This could cause an explosion in hazardous
location installations.
Be sure that power is removed or the area is non-hazardous before proceeding.
3
Press on the module lock on the top of the module and pull up on the I/O module
to remove from the base.
Warning: When you insert or remove the module while backplane power is on, an electrical arc
can occur. This could cause an explosion in a hazardous location.
Be sure that power is removed or the area is non-hazardous before proceeding.
4
Remove the module to the right of the base. The interlocking portion of the base
sits under the adjacent module.
5
Use a small screwdriver to rotate the orange DIN-rail locking screw on the
mounting base to a vertical position. This releases the locking mechanism.
6
Lift the mounting base and remove.
