PT-1207 User’s Manual
www.prokits.com.tw
7
When the battery pack is in the charging status, the red light on the left side will
be lit up. The charging time is around 1 ~ 1.5 hours. After the power is full, the
red light will turn off and the green light on the right will turn on. Before
removing the battery from the charger, please remove the charging plug first.
Important!
Only use the provided battery charger for battery charging.
Temperature Dependent Overload Protection
When using as intended, the tool cannot be overloaded. In case of excessive
loading or when exceeding the allowable battery temperature range of 0
– 50 °
C, the speed is reduced or the tool switches off. In case of reduced speed, the
tool will not run at full speed until after reaching the allowable battery
temperature again. In case of automatic shut-off, switch the tool off, allow the
battery to cool down and then switch the tool on again.
Battery Indicator
The three blue LEDs of the battery indicator indicate the charge condition of the
battery . For safety reasons, it is only possible to check the status of the charge
condition when the tool is at a standstill. Press the button to indicate the charge
condition.
Inserting tool bits
Important!
Always remove the battery before you change the drill or screw bit to
avoid unintentional starting of the machine.
The cordless driver has a keyless chuck so you do not need a key to lock the
tool bit in place. Make sure that the socket or screw bit is not skew when it is
inserted and the chuck tightened.
Pull the locking sleeve forward, push the tool bits to the stop into the tool holder
and release the locking sleeve to lock the tool bits.
Pull the locking sleeve forward and remove the insert bits.
