Proroute H685, Руководство пользователя

Страница: 30 / 109

E-mail: support@proroute.co.uk www.proroute.co.uk
Pressing the ‘Reset’ button as seen in the picture above, will reset the router to the factory default
settings. After clicking the button, a confirmation button will appear. Press this and the system will
reset.
2)
The Reset Pin on the terminal strip. Short the RST and GND terminals for 3 seconds and the
modem will restore to factory defaults. Holding for 1 second will reboot the modem.
3)
Hold in the “RST” button, just below “CELL 1” on the Antenna end of the router for approx.
10 seconds. Note: There is no immediate indication that the reset has been performed.
Release the button and after about 10 seconds you will see all the LED’s go OFF then the
WAN & LAN will come ON briefly then go OFF. The LAN will come ON and flicker with traffic,
the SYS led will come ON for approx. 25 seconds then start to flash and the Wi-Fi LED will
come on. This is good indication that the modem has reset as the Wi-Fi is enabled by default.