Proroute H685, Руководство пользователя

Страница: 10 / 109

E-mail: support@proroute.co.uk www.proroute.co.uk
As standard the H685 4G comes with 4x stick antennas and 4x magnetically mountable
antennas. These have SMA male connectors.
To install the antennas, place antenna connector on the router’s connector and turn clockwise
until tight. To remove antenna, turn anti-clockwise.
Please note
The mag-mount antennas will only function correctly when the base it placed on a flat metal
surface at least 30cm x 30cm in size.
The 4G modem requires 2x antennas connected on Cell1 and Cell2 to allow max functionality
and to pick up the strongest signal possible. Although some applications (usually running at
lower data speeds) may function well with one antenna.
2.5 Installation of terminal block
As standard the H685 router comes with a terminal block, this will be pre-installed already
connected to the body of the router and does not need to be altered.
This enables the use of pluggable terminals, these can be used to give power to the unit,
and to connect and transfer data also.
Terminal block specifications Units
Spacing 3.81mm
Number of Pins 10
Suggested Wire gauge 14~24AWG
To install wires into the terminal block, make sure the router is not connected to power,
and remover remove terminal block from router. Remove the terminal block by gently
pulling unit out of the router.
Use a small flat-headed screwdriver to open and close the individual terminals. Open by
turning screwhead anti-clockwise, insert wire, then secure by turning screwhead
clockwise.