Page 3 of 6
1
Insert 2 x M6 Spring Nuts at an equal distance from the ends of each crossbar. Push
Spring Nuts down into the crossbar channels and twist to lock into place as pictured.
Use the Rod Holder Body to ensure Spring Nuts align with the two rear holes in the
base of Rod Holder Body.
2
Position the Rod Holder Bodies on each crossbar with the strap/foam ends pointing
towards each other. Secure the 2 x Rod Holder Bodies to the M6 Spring Nuts in the
crossbars using the M6 Button Head Capscrews 20mm and M6 Spring Washers via
the rear holes as shown. Tighten to 4Nm with 4mm Allen Key Screwdriver provided
or a suitable Torque Wrench.
4
To secure rods, push the Zip Straps into the Buckles on either side of the Rod
Holders.
To release, push the top end of the Buckles inwards and lift Strap.
3
Your Fishing Rod Holder is now fitted and ready for use.
To use, place handle end of rod back into the main opening of the Rod Holder Body
and down into the foam. Place the rod tip into the foam on the opposite Rod Holder
Body as shown. Repeat for multiple rods, utilising the opposite end as required.
INSTALLATION ONTO TRADESMAN AND OTHER HEAVY DUTY CROSSBARS
