PROPOINT 8977084, Руководство пользователя

Страница: 6 / 32

8977084 TRUBLU LoPro Welding Mask Kit V1.0
6 For technical questions call 1-800-665-8685
ASSEMBLY & INSTALLATION
Letter references in parenthesis (A) refer to the included Identification Key.
The welding mask is preassembled. Remove the protective film from both
lenses before use.
SWITCHING HEADBANDS
The welding mask has two headbands: plastic (F) and elastic (G).
Switch out the headbands by pushing on
the headband’s lock catch until it pops
off. Repeat on the other side.
Push the lock catch against the locks on
each side of the goggles (Fig. 3) until
they snap into place.
ADJUST THE WELDING MASK FIT (PLASTIC
HEADBAND)
The headband should be adjusted both in diameter and height.
1. Adjust the headband diameter with the adjusting knob on the headband.
Twist clockwise to tighten and counterclockwise to loosen.
2. Adjust the headband height by releasing the segmental positioning
plate and changing the top strap hole.
ATTACH THE LED LIGHT
1. Place the light’s base in front of the face plate’s bracket.
2. Align the bracket’s tabs with the base’s slots.
3. Push the light backwards until it touches the bracket’s backstop.
4. Remove the light by pulling it forward until it is free of the bracket.
OPERATION
WARNING! Do not weld if the orange light inside the goggles is
flashing. This is the Grind mode indicator and you can suffer eye
or retina damage, as the lens will not darken when the welding
arc forms.
Fig. 3