3
4
DO NOT FLY YOUR HD VIDEO DRONE IN FOUL WEATHER!
WARNING
CONTROLLER DIAGRAM
Battery Eject lever
Power Indicator Light
Left Control Stick
Throttle Speed Trim
Auto Land Button
Forward/Backward Trim
Right Control Stick
Power On/Off
Left Turn/Right Turn Trim
Left Bank/Right Bank Trim
Left Bank/Right Bank Trim Indicator
Rotor Blades
Front (White Light)
Back (Red LED Light)
Landing Gear
Digital Camera
Still Photo &
Video Recording Button
3/4 CH & Speed Button
360
˚
Stunt Roll Button
Battery Capacity Indicator
Camera Snap Shot Indicator
Video Recording Indicator
Auto Land Indicator
Channel Mode Indicator
Speed Indicator
Channel Mode Indicator
Left Turn/Right Turn Trim Indicator
Throttle Trim
Indicator
Camera Indicator Light
Micro SD
Card Slot
battery
compartment
CH1: 50%
3 4 CH
2
00
HOLD
Forward/Backward Trim Indicator
HD VIDEO DRONE DIAGRAM
FLIGHT PREPARATION
• Verify that there are 6 “AA” batteries inside the remote control unit and the HD Video Drone has been
fully charged.
• Make sure to be in a large open space preferably a field or a park with an open radius of at least 200 feet.
• Make sure to start your drone on a clean flat level surface before take-off.
• IMPORTANT! Until you have experience in flying your HD Video drone, it is not advised to use in any
rate of wind. Wait until a zero wind day or extremely light wind when learning how to fly.
SYNCING YOUR HD VIDEO DRONE
Important! When syncing your HD Video Drone with the controller always make sure that the drone
is on a flat level surface and that your digital trim settings are in the center position. This insures
that the 6 Axis gyro is properly programmed to respond to your trim settings.
Your HD Video Drone
utilizes an automatic 2.4G channel selection system that allows up to 8 people to fly side by side in the
same wireless range with no interference.
1. Before starting, make sure that the power switch on your controller is off and the battery is removed
from the HD Video Drone. Make sure that there are no other 2.4G devices in the area.
2. Insert the battery into the HD Video Drone and set it down on any flat surface. The red and white LED
lights on top of the drone should begin to flash repeatedly.
3. Quickly turn ON the remote and you will notice that the top red LED light on the face of the controller
should also be flashing.
4. Push the left control stick all the way up until it stops and then pull it back all the way down to the
bottom(see illustration below). When pulling the stick down to the bottom you should hear a
high-pitched beep and the lights on both the drone and the controller should stop flashing and become
solid. If the lights on both the drone and the controller have stopped flashing and become solid you have
successfully synced your HD Video Drone and are ready to fly. If the lights on the controller or the drone are still
flashing repeat steps 1-4 again.
• TIP 1: try not to leave too much time between putting your battery into the drone
and turning on the controller or your syncing window will time-out.
• TIP 2: Syncing your drone indoors or in the shade will make it easier to see the LED
light indicators on both the controller and the drone.
move the control stick all the way
up and all the way down you
should hear a beep
the flashing red LED light will
become solid when you are
synced
