pronovost SilaTube P-6500, Руководство оператора и каталог запасных частей

Страница: 25 / 56

- 25 -
5
MAINTENANCE
1) Refer to the manufacturer’s instructions for the
engine.
2) Use a high quality lithium base grease containing
molybdenum disulfide (MoS
2
) such as «Esso
Unirex EP1 Moly», «DARINA XL-Multi Season
Moly, Grade #1» from Shell or equivalent.
3) Wipe off all grease fittings with a clean cloth
before adding grease in order to avoid injecting
dirt or sand.
4) Repair or replace damaged grease fittings.
5) Lubricate stretcher arms guides every 20 hours of
operation.
6) Lubricate all grease fittings every 20 hours of
operation.
7) Open, clean and lubricate wheel bearings once a
year.
Adjust the bearings as follows:
a- Lubricate spindle threads.
b- Screw the adjusting nut on the spindle thread.
c- Set a bearing preloading by torquing the
adjusting nut to 200 ft-lbs to make up for any play
between parts.
N.B.: This step must be carried
out while rotating the wheel.
d- Loosen the adjusting nut one complete turn.
e- Now tighten it again to a 50 ft-lbs torque.
f- Loosen the nut 1/4 turn; while doing so,
determine the right position for the locking device.
g- Install the locking device.
8) Check oil level in hydraulic reservoir every 20
hours of operation. If necessary add good quality
trans hydraulic oil such as «Trans Hydraulic
Duratran» from Petro-Canada, «DONAX TD»
from Shell or equivalent.
9) Change oil filter after the first 50 hours of
operation and then every 250 hours. Use replace-
ment filter no. K-22001, PRONOVOST part No.
32007.
10) Check all nuts and bolts once a year. If necessary
use torque chart on page 51.
11) Check all bolts on wheels after first 5 hours of
operation and then every 50 hours.
12) Check tire pressure every 50 hours. Adjust
according to manufacturer’s recommendation
indicated on the tires.