pronovost SilaTube P-6500, Руководство оператора и каталог запасных частей

Страница: 22 / 56

- 22 -
OPERATION (cont'd)
12) Apply a light tension to the tube, pull out the outer
ply of plastic for approximately 18" (45 cm) (Fig.
44) and replace it on the tip of stretchers (Fig. 45).
In this way, it will be easier to pull out when it
will be time to close the end of the tube.
13) You will finish to stretching the tube after the
introduction of the first bales in the SilaTube.
14) Before introducing the first bales, place the switch
for the pusher on manual mode (Fig. 46).
15) Operate the control valve manually until the first
stack of bales goes beyond the stretchers ends by
about 6" (15 cm).
16) CLOSING OF THE END OF TUBE: Let the
two stretchers going inward until they touch
lightly the bales. In this way, the plastic will be
easier to slide. Pull out enough plastic to close,
and tie the tube properly as shown (Fig. 47).
Do
not forget : stretch the tube again to introduce
freely the bales in the tube.
4
Figure 44
Figure 45
Figure 46
Figure 47
AUTO
MAN