Additional Instructions -
Built In O3Elite Dual Ozone
Generator - SSPO3-OZ
1.
Attach the power cord to the
ozone generator and plug it into a
wall outlet.
2.
Remove the dust caps. Plug tubing
from your oxygen source into the
Oxygen In port.
3.
Attach the three way stopcock to
the Ozone Out port. Attach a piece
of silicone tubing to the horizontal
arm of the stopcock and attach the
other end of that tubing to the Ozone In port on
the sauna. Make sure the check valve is closer to
the Ozone In port as shown.
Note:
Until you are
ready to turn on the ozone, or any time the sauna
is heating up or being used without ozone, make
sure the Off on the stopcock is pointed to the
horizontal. When you’re ready to start directing
ozone into the sauna, turn the Off to the vertical
position.
4.
Turn on your oxygen source. Turn the ozone
generator dials to the settings desired. Use the
gamma chart on the next page to determine the
settings needed to obtain your desired level of
ozone.
5.
When your session is complete, turn off the
ozone generator. Let the oxygen run for a a
couple of minutes and then turn off your oxygen.
Note about the Built In Ozone Model:
This
model can be used for ozone saunas or separately for other ozone applications.
To use the ozone generator with other applications, connect silicone tubing to
the vertical arm of the stopcock. Make sure Off is pointed toward the horizontal
arm of the stopcock to divert ozone to that application.
Ozone Dials
Power
Oxygen In
Ozone Out
Ozone In
Horizontal
Vertical
