Promise Technology Ultra100 TX2, Руководство пользователя

Страница: 20 / 39

Ultra100™ TX2 User Manual
16
Installing Drivers with Existing Windows 95
1. After installing the Ultra100 TX2 controller card and configuring the hard
drives (see “Hardware Installation” on page 5), power up the system and
boot Windows.
2. The “Update Device Drive Wizard” will appear, informing you that it has
found a “PCI Mass Storage Contro ller.”
3. Insert the “Ultra100 TX2 Driver” diskette in drive A:.
4. Click on “Next.” Windows will inform you that it has found the “ Win9x-ME
Promise Ultra100 TX2™ IDE Controller
”
5. Click on “Finish,” and when prompted to insert the “Ultra100 TX2 Driver”
diskette, click on “OK.”
6. If a message informing you that the file “ULTRA.MPD” cannot be found, go
to the “Copy files from:” text box and type: “A: \ WIN9X-ME”.
7. Choose “Yes” when asked whether you want to start your computer. Be
sure to remove the diskette from drive A.
Confirming Driver Installation in Windows 95
To confirm that the driver has been properly loaded in Win 95/98, perform the
following steps:
1. Choose “Settings” from the “Start” menu.
2. Choose “Control Panel,” and then double -click on the “System” icon.
3. Choose the “Device Manager” tab, and then click the “+” in front of “SCSI
controllers.” “ Win9x-ME Promise Ultra100 TX2™ IDE Controller
” should
appear.
DOS/Windows 3.1x
For first-time installation, follow the standard procedure of installing DOS onto your
hard disk (partition all hard drives with FDISK and format before performing the
following procedure):
1. Insert “Disk 1” of your DOS installation diskettes into drive A:.
2. Type “A:SETUP” at the “A: \” prompt.
3. Continue with normal DOS installation procedure, and refer to your DOS
manual for additional details.
NOTE : The Ultra100 TX2 BIOS supports both DOS and Windows 3.1x without
software drivers.