Promise Technology 150TX2, Руководство пользователя

Страница: 17 / 82

Chapter 2: Installation
13
Creating a Security Array with an Existing Data Drive
Caution
With some models of hard drives, if the Master hard drive fails, it
may cause the Slave hard drive to be unrecognized by the
computer's operating system. Where a RAID 1 (Mirroring) array
exists on the Master/Slave pair, this condition may cause the
operating system to freeze.
Do NOT create a RAID 1 (Mirroring) array with two Parallel ATA
hard drives using the Master/Slave arrangement on Channel 3
(the Parallel ATA port).
You can create a RAID 1 (Mirroring) array by combining hard
drives on:
• Channels 1 and 2 (Serial ATA only)
• Channels 1 and 3 (one Serial, one Parallel)
• Channels 2 and 3 (one Serial, one Parallel)
Use this setting to create a Mirrored (RAID 1) array with a new hard drive and an
existing drive with data and/or the bootable system drive in your system. Use a
new drive of identical or larger storage capacity as the existing drive.
Warning
If you are creating a Security array using an existing hard drive,
backup any important data. Failure to do so could result in data
loss.
Important
If you wish to include your current bootable drive using the
Windows NT 4.0, Windows 2000, or Windows XP operating
system as part of a bootable Mirrored (RAID 1) array on your
FastTrak S150 TX2plus, do NOT connect the hard drive to the
FastTrak yet.
You MUST install the Windows NT4, 2000, or XP driver software
first to this drive while it is still attached to your existing hard
drive controller. See chapter 4 of this Manual.
Follow these steps:
1. Press the Spacebar to choose Security under the Optimize Array for
section.
2. Press Ctrl-Y to Save your selection. The window below will appear.