AMMONIA User Manual
AMMONIA_User 9/09
5
2
5.4 Enabling Inputs & Outputs
To enable a sensor, or contact set input
press
ENTER
and
DOWN
to
Enable I/O
at the power up or day-time display..
Key
ENTER
@
Enable I/O
.
In this Analyzer 12 of the 26 sensor, meter-volume
and contact set inputs are unused..
Key
ENTER
to select one.
Key
UP
or
DOWN
to scroll through the
unused, disabled inputs
Key
ENTER
select one
or
EXIT
to not select any inputs.
In this example we’ll
FlowSwitch_S
.
After enabling, scroll to
FlowSwitch_S
input,
re-name it and configure it for use.
Enable an Input
Enable I/O
Passwords
then
Enable Inputs
12 unused
Thu 16:54:10
S/N: A076X0486
Enable Inputs
SensorInput_K
or
Enable Inputs
FlowSwitch_S
Sidebar:
Enabling Inputs:
In each Analyzer there are 26 inputs; 14 Sensors ‘
A
’ to ‘
N
’
and 12 Meter-Volume or Contact Sets ‘
O
’ to ‘
Z
’.
Of the 14 sensors, 7,
A-G
, have terminal blocks where you can connect actual sensors
and 7,
H-N
, are ‘Phantom’ and are used for manual and calculated values.
Of the 12 Meter-Volume or Contact Sets, 8,
O-V
have terminal blocks where you can connect
actual meters or contact sets and 4,
W-Z
are ‘Phantom’ and are used for copy targets and
mirroring.
Enabling Outputs:
Outputs are enabled in the same way as inputs. Each Analyzer has 5 outputs.
Outputs
1-5
are relays which switch Analyzer AC power to turn ON and OFF