7
ASSEMBLY INSTRUCTIONS
Secondary
Support
Screw
Open Loop
Support
Washer
Secondary
Spring
Washer
Secondary
Support Screw
Braided Cable
Outlet Box
Brace
5
6
7
6. Install secondary support screw, secondary spring
washer, and support washer partly into the side of the
brace installed in the ceiling. Then lift the braided cable
up and over the ceiling brace and place the open loop of
the braided cable around the secondary support screw.
Note:
The ceiling support brace may not be accessible
from below. If not, it must be accessed from above.
Important:
The braided cable must make a complete
circle around the support brace to secure the fan.
7. Tighten the secondary support screw securing the
braided cable.
SECONDARY HANGING SYSTEM
For installation in the United States:
Building codes
in the U.S.A. do not require installation of a Secondary
Hanging System. If desired, the braided cable can be cut
and removed using wire cutters (sold separately).
Skip to
Step 8.
For installation in Canada:
In compliance with building
codes in Canada, installation of the Secondary Hanging
System is required.
5. Feed the loop of the braided cable, preassembled to
the motor assembly, up through the outlet box mounted
in the ceiling.
WARNING:
Do NOT
wire the fan to a wall
control.
Wire Connector
White (neutral)
Black
Black (hot)
Whit
e
8. Connect supply and fan wires according to the diagram
and these steps:
• Connect the Green wire from the mounting bracket to
the Bare/Green (ground) supply wire.
• Connect the White wire from the fan to the White
(neutral) supply wire.
• Connect the Black wire from the fan to the Black (hot)
supply wire.
• Secure all wiring connections together with wire
connectors.
Note:
The Black wire is hot power. The White wire is
neutral. The Green wire is the ground wire. If supply wires
are different colors than referred to above, a professional
electrician should determine the proper wiring.
8
Содержание Eclora 51672
Страница 1: ......