MAINTENANCE MANUAL //
STRETCHER PC-750 + RAIL PB-720
Revision 2021/10
7
4.1 STRETCHER
4.1.1 CONTROL PANEL:
☐
Check the condition of the membrane and consider whether it needs to be replaced. It should be con-
sidered that the membrane is an element that suffers a lot of wear and if it is in bad condition it could
have a fault. If it is in poor condition, it is recommended to change it before it stops working as otherwi-
se it could compromise a service.
4.1.2 LOWER STRUCTURE:
☐
Check the condition of the reflective stickers and consider whether it is necessary to replace them.
☐
Check the condition of the adhesives and consider whether it is necessary to replace them
4.2 RAIL
4.2.1 FIXED RAIL OPERATION:
☐
Check the condition of the adhesives and consider whether it is necessary to replace them.
4.2.2 FIXED RAIL OPERATION:
☐
Check the condition of the adhesives and consider whether it is necessary to replace them.
4.1.3 LEGS:
☐
Make sure that the rotation shaft bolts are properly tightened.
☐
Check the tightening torque of the screws that connect the legs
to the upper part of the stretcher (see Fig. 8). The tightening tor-
que must be 19.11 Nm.
☐
Make sure that the limit switch sensor is properly tightened and
fixed.
☐
Clean the upper and lower guides and renew the lubrication with
Vaseline. IMPORTANT: after greasing, always clean the excess.
☐
Check the condition of the adhesives and consider whether it is
necessary to replace them.
4.1.4 PROFILE:
FIGURE 8
04
EVERY 3 YEARS
