Included in single light:
•
1 – ProMaster VL-380 Portable Studio Light
•
1 – 7.75” Reflector
•
1 – Double-Diffused Softbox
•
1 – AC Adapter for VL-380
Included in double light kit:
•
2 – ProMaster VL-380 Portable Studio Light
•
2 – 7.75” Reflector
•
2 – Double-Diffused Softbox
•
2 – AC Adapter for VL-380
•
2 – 6’ Light Stand
Power Options
The ProMaster VL-380 can accept three different power sources; AC power, AA batteries, or the optional
rechargeable lithium-Ion battery.
To power by AC, plug the included AC adapter into the AC adapter input and plug into a standard
household socket.
To power with AA batteries, open the battery door and remove the AA insert. Fill the insert with 10
alkaline or rechargeable AA batteries making sure polarity is correct. Then place the AA insert back into
the VL-380 and close the cover.
To use the optional Lithium-Ion battery, make sure to initially charge the Lithium-Ion battery by plugging
it in using the included charger cable for 4-6 hours. This will give the battery a full charge and will ensure
that future charges use the entire battery capacity. Next, remove the battery door and insert the battery
making sure that the positive and negative contacts on the battery match those on the VL380.
Brightness is controlled by the Variable Power Dial which also acts as the VL-380 power On/Off switch.
Attaching the Reflector
Your PROMASTER® VL-380 LED Studio Light is shipped with both a reflector and a 24” softbox. To attach
the reflector, slip the slots on the reflector over the pins on the lamp head and tighten the reflector
locking knob. Make sure the umbrella slot is on the bottom if you intend to
use an accessory umbrella.
Attaching the Softbox
The softbox comes with attachment rods. One end of each rod should be
inserted in the rod pocket in each corner of the softbox reflector (See figure
1). Spread out the softbox reflector by opening the Velcro® fastening points,
and then put the light body into the opening. Make sure the light stand
bracket is facing you.
Figure 1
