Promac SY-315, Руководство пользователя

Страница: 12 / 59

SY-315 / SY-315L
- Place the work-piece on the flat surface in between the
vice jaws.
- Align the workpiece on the saw blade and make sure
that the workpiece is positioned completely against the
rear clamp jaw.
- Tighten the workpiece as described under 9.2.
9.4 Setting cutting length
The length of the workpiece can be set with the
longitudinal stop.
- Set the desired workpiece length according to the scale
on the stopper bar (C).
- Insert the workpiece in the vice with the end of the
workpiece touching the stopper lug (B), then tighten the
adjustment screws (A)
- Tighten the workpiece with the quick action stick lever.
- Check the length of the workpiece.
9.5 Operation cycle
START
- Set the head to the desired angle.
- Open the vice enough.
- Adjust the fence.
- Load the work-piece.
- Clamp the work-piece.
- Set the desired rotations on the rev selector (5).
- Set the coolant switch (4) if necessary.
- Press the operating button (2).
- Grasp the control handle (G) and start the machine by
pressing the trigger switch (F).
Pull down the control handle (G). Apply a steady and
constant pressure.
After cut off
-
Raise control handle slowly
- Release the trigger switch (F), machine will stop.
- Press the stop button (1)
- Use vice lever to open the vice
- Remove or feed the workpiece forward
9.6 Setting the mitre adjustment lever
If it is not possible to release or tighten the adjustment lever
of the mitre adjustment on the saw head sufficiently, then the
lever has to be repositioned.
- Release screw (A), then put the push with the screw bolts
(B) in the correct position on the mitre adjustment lever (C)
and tighten screw (A).
12