http://prolux.net.ua
15
4)
【
CLEAR
】
is clear the value of
【
R1
】
,
【
G1
】
...
【
SHUT
】
then save
and reset.
9 OPERATING CONTROL INSTRUCTION
Master/Slave
When the fixtures work in master mode it will send out the signal for
the slave synchronous with it. To avoid the host signal and DMX512 signals
interfere with each other, should cut off the DMX512 signals. The signal lines are
longer than 60 meters (20 lamps), should increase a signal amplifier.
10 XLR CABLE CONNECTING
The standard connection way of the XLR is: one end connects to the male plug,
and the other connects to the female. As below: pin 1: ground, pin 2: negative
signal, pin 3: positive signal.
Noted: In order to avoid failures and interference signal transmission, we connect
a
resistance120Ω (1/4W) at the end of the DMX connecting as below:
Termination reduces signal errors and avoids signal transmission
problems and interference. It is always advisable to connect a
DMX terminal, (Resistance 120 Ohm 1/4 W) between PIN 2
(DMX-) and PIN 3 (DMX +) of the last fixture.
The Conversion between 3 pin and 5 pin XLR
If the output cable of DMX512 controller is the 5PIN, please use 1pc 5PIN to 3PIN
cable.
3-Pin XLR to 5-Pin XLR Conversion
Conductor
3-Pin XLR Female (Out)
5-Pin XLR Male (In)
Ground/Shield
Pin 1
Pin 1
Data Compliment (- signal) Pin 2
Pin 2
Data True (+ signal)
Pin 3
Pin 3
Not Used
Do Not Use
XLR pin configuration
Pin 1 = Ground
Pin 2 = Data compliment
(negative)
Pin 3 = Data true (positive)
