16
Chapter 8
OPERATING INSTRUCTIONS
2. Insert the SD card, with the label side down.
3. Press the reset button, and the five buttons will light in sequence from left to right.
4. The
:
and
E
buttons will light alternately.
5. Press and hold
:
for one second, and the display will show
LOAD
for about ten seconds.
6. The five buttons will light in sequence from left to right.
7. Remove the SD card; the display will show the currently loaded firmware version and the pump
will run for one second.
8. Press
:
to turn on the power.
9. Press
I
to cycle through the modes to the
RUN PROGRAM
mode.
10. Press
L
to view the start time for the first program.
11. Press
L
again to view the stop time for the first program.
12. Press
E
or
F
to view the second and third programs.
13. Be sure the power is on and the appliance is in
RUN PROGRAM
mode prior to closing and
locking the door.
Copying programs to an SD card
1. Insert a FAT32 formatted SD card, with the label side down.
2. Press the reset button, and the five buttons will light in sequence
from left to right.
3. The
:
and
E
buttons will light alternately.
4. Press and hold
E
for one second, and the display will show
SAVE
for
about ten seconds.
5. The five buttons will light in sequence from left to right.
6. Remove the SD card; the display will show the currently loaded firmware version and the pump
will run for one second.
7. Press
:
to turn on the power.
8. Be sure that the power is on and the appliance is in
RUN PROGRAM
mode prior to closing and
locking the door.
9. The new file created on the SD card will be called “outsche.txt.” Changing it to “schedule.txt”
allows the programs to be loaded on another appliance.
8
