Clean and dry the inside as instructed under the heading of cleaning the fridge.
Leave the door open to prevent any smells from building up while the fridge is not in use.
Replacing the light bulb
1
Before carrying out the bulb replacement always unplug from the electrical supply.
The Internal light is located behind the Thermostat Control Dial panel.
2
Remove the small screw located at the back of the light cover.
3
Remove the old bulb by unscrewing in an anti-clockwise direction.
4
Replace with a new E14 screw cap type bulb (15w) by screwing it firmly in the holder.
5
Re-fit the light cover and replace the small screw to fix it in place.
Reversing the door
1.)
Unplug the product from the mains supply.
2.)
Tilt the product backwards and lean it against a wall.
3.)
Remove the four bolts fixing the bottom hinge and remove the hinge plate.
4.)
Lift the bottom of the door and slide downward to remove the door.
5.)
Remove the hinge pin insert from the door.
6.)
Remove the blanking cap from the opposite side and insert it in the original hole.
7.)
Insert the hinge pin insert in the remaining hole.
8.)
Remove the two screws holding the hinge pin to the top of the door cavity and transpose
to the opposite recess.
9.)
Transfer the door hinge and door-stop screws to the other side of the bottom hinge plate.
10.)
Re-fit the door to the top hinge pin and align with the door cavity.
11.)
Remove the self-tapping screw from the new position of the bottom door hinge plate a
and re fit to other side (see NOTE).
12.)
Re-assemble the bottom door hinge in the reverse order of removal.
13.)
Check the door is aligned and that the seals are in contact with the door cavity all
around the door.
NOTE:
Use the self tapping screw to clear the bottom hinge plate holes if required. Re-fit to opposite
side for storage.
It is our policy to continualy seek new ways of improving our products. Therefore we
reserve the right to change the specification of items illustrated and described, at any
time and without notice.
