Cautions
4
Figure (3)
Power line connection
eul
b
woll
ey-
ne
er
g
N2
N1
L2
L1
yer
g
n
wor
b
kc
al
b
220-240V
220-240V
eul
b
woll
ey-
ne
er
g
N
L
yer
g
n
wor
b
kc
al
b
220-240V
PE
PE
connet to the main power supply
connet to the main power supply
220-240V 2+2N~
220-240V~
1. The ceramic hob must be installed by qualified personnel or technicians.
Never conduct the operation by yourself.
2. Do not install the hob close to refrigeration appliances or dishwashers and
rotary dryers.
3. The ceramic hob shall be installed such that good ventilation can be
achieved to assist reliability.
4. The wall and induced heating zone above the table surface shall withstand
heat.
5. To avoid any damage, the sandwich layer and adhesive must be resistant
to heat.
6. A steam cleaner is not to be used.
7. A board is must to be installed underneath the hob
The socket shall be connected according to the relevant standard or
connected to a single-pole cut-out. 30 minimum supply. The method of
connection is shown in Figure (3):
A qualified electrician must ensure that the correct electrical connection
made and that it complies with wiring current regulations in force.
prepared lead by a qualified electrician to avoid a hazard.
If the hob is to be connected directly to the mains an omnipolar circuit-breaker
must be installed with a minimum opening of 3mm between contacts. The
installer must ensure that the correct electrical connection has been made
and that it complies with wiring rules.
The cable must not be bent or compressed. The cable must be checked
regularly and if required replaced by a qualified electrician.
7
If the mains lead becomes damaged, it must be replaced with a specially
